VentMed CPAP User Manual page 23

User Guide
Problem/possible cause
High leak detected, check water
tank, tank seal or water tank cover
Water tank may not be inserted
properly.
Water tank seal may not be inserted Open the water tank and make sure that
properly.
Droplets of water on nose, in the
mask and air tubing
Humidity level may be set too high. Adjust the Humidity Level.
Mouth is very
uncomfortable
Air may be escaping through mouth.
High leak detected, connect your
tubing
Air tubing may not be connected
properly.
Mask may be fitted incorrectly.
Tubing blocked, check your tubing
Air tubing may be blocked.
SD card error
SD card may not be inserted correctly. Power off the device, remove and
Air filter blocked
Water in the air tubing
All other error messages
Solution
Make sure the water tank is correctly
inserted.
the seal is correctly inserted.
and Increase the Humidity Level.
dry
You may need a chin strap to keep your
mouth closed or a full face mask.
Make sure the air tubing is firmly
connected at both ends.
Make sure mask is fitted correctly. See
your mask user
guide for fitting instructions or use the
Mask Fit function to check your mask fit
and seal.
Check the air tubing and remove any
blockages.
reinsert the SD card.
Check the air filter and replace it if there
are any blockages.
Empty the water from the air tubing.
Disconnect the power
supply and then reconnect it to restart
the device.
Contact your care provider. Do not open
the device.
22
VentMed