Table of Contents
Advertisement
Changing the light bulb.. .
Unplug lhe refrigerator
before changing
the llghl
bulb.
I, Reach behind control console to find bulb.
2. Remove bulb.
3. Replace
with a 40.watt
[maximum]
appliance
bulb.
Adjusting the refrigerator
shelves...
1 First, remove fo&
from shelf.
2. Slide shelf straight out to stop.
3. Lift front.
4
Shde the rest of the way out
Shelf Stop a/m
Replacing
Shelf:
1 Fit back of shelf on top of guides with wire stops
on the bottom
of guides
2 Ltft front, slide shelf In until It clears guide stops
Removing crisper and crisper
cover.. .
Lift
the
Front.
Then the Back.
Ice cube trays...
To remove
ice:
1. Hold tray at both ends.
2 Slightly twist.
!w
'Shelf
Guide
Removing Crisper:
l
Slide crisper straight out.
Remove Cover:
I. Lift back, then slide to the rear
until the front can be Med.
2. Lif-t cover up and out.
Replacing
Cover:
I, Slide the front cover tabs into
the back of the front supports on
the refrigerator
wall.
2. Lower back into place.
If cubes are not used, they may shrink The moving
cold air starts a slow evaporation.
The longer cubes
are stored, the smaller they get.
Souncls you may hear.. .
Your new refrlgerotor
may make sounds that your old one dldn t
Because the sounds ore new to you. you might be concerned
about
them Don t be Most of Ihe new sounds are normal
Hard surfaces llke
the floor. walls and coblnets
can make the sounds seem louder
The followlng
chart describes
the kinds of sounds that might be new
to you and what may be maklng them
Poutbte
Sounds:
l
Water
Sounds:
l
Running
Sounds:
6
Probable
Causes:
When the refrigerator
stops running. you may hear gurgling
In the tubing for a
few minutes after tf stops
Your refrigerator
has a high-efflclency
compressor
and motor If WIII run longer
than older designs
It may even seem to run most of the time
Advertisement
Table of Contents
