Part I Introduction; Computer Requirements - Vision Engraving & Routing Systems VR48 5 Series Installation Manual

4 Vision VR48
1 Introduction
This guide contains information to prepare the owner of a Vision VR48 for the proper installation of their
machine. It is the customer's responsibility to read through this guide and make sure the work area,
electrical and computer requirements are met. If for any reason, there are questions about these
requirements, please call your Vision representative as soon as possible.
In the following sections, the complete machine and Vision software installation will be outlined.
Please call or email your Vision distributor or the Vision service department at Vision for assistance if
you have any questions with this procedure. The Vision service department phone number is 1-602-439-
0600 and the email address is service@visionengravers.com.
FOR MORE DETAILED INFORMATION, PLEASE REFER TO THE USER GUIDE FOR YOUR MACHINE
INSTALLED WITH THE VISION SOFTWARE. USER GUIDES ARE ALSO AVAILABLE ONLINE AT
http://www.visionengravers.com/support/vision-engraver-manuals.html
1.1

Computer Requirements

Minimum System
Requirements:
CPU:
Hard Drive:
RAM:
Operating System:
Ports:
Suggested System
Requirements
CPU:
Hard Drive:
RAM::
Operating System:
Ports
Intel i5 2.6-3.0GHz
5 GB free space
8 GB
Windows 10 (32/64 bit)
Windows 8 (32/64 bit)
Windows 7 (32/64 bit)
NOTE: Windows updates must ALL be installed
1 USB port for security dongle
1 USB port for Ethernet adapter to connect machine
Intel i7 2.6-3.0GHz (or faster)
500 GB SSD (or larger)
16 GB (or more)
Windows 10 (64 bit)
1 USB port for security dongle
1 USB port for Ethernet adapter to connect machine
© 2020 Vision Engraving & Routing Systems