Motorola MG8702 User Manual page 72

How to Tell if Your Clients Support WPA2
You can check to see if all other clients that you plan to put on the
network support WPA2. You can do this by checking the manual that
came with each device or by checking the configuration software for
the installed device. Look under Security or Encryption or Setup or
Advanced Features.
How to Configure Wireless Security for a RADIUS
Server
If you have a Radius Server, select the WPA/WPA2 options without
PSK. To enable WPA and WPA2 without PSK, follow these steps:
1. Under 802.11n Mode Enable/Disable, select Disable from the
pulldown.
2. Find the WPA-PSK Security Settings tab. If WPA-PSK is Enabled,
select Disabled from the WPA-PSK pulldown and click Save. (Note
that WPA-PSK is Disabled by default).
3. If WPA2-PSK is Enabled, select Disabled from the WPA2-PSK
pulldown and click Save. (Note that WPA2-PSK is Enabled by
default).
4. Select Enabled for WPA2. Do not click Save yet.
5. Enter the RADIUS Server Address and click Save.
6. Enter the RADIUS Port and click Save.
7. Enter the RADIUS Key and click Save.
8. If you want to enable WPA, select Enabled for WPA, and click Save.
9. If you want to enable WPA2, make sure Enabled is selected for
WPA2, and click Save.
10. If you want to disable WPA2, select Disabled for WPA2, and click
Save.
11. Under Encryption, if you have enabled WPA, or WPA and WPA2,
select AES+TKIP. If you have enabled WPA2 only, select AES only.
12. Click Save.