Table of Contents
Advertisement
Changing
the light bulbs.. .
WARNING: Before removing
a light shield
for
cleaning
or for replacing
the bulb,
light bulbs behind refrigerator
and freezer con-
either
unplug
refrigerator
or dis-
trol consoles:
connect
electricity
leading
to re-
1 Pull control knob strarght off.
frigerator
at the main power supply.
2. Pull bottom of control panel strarght out.
Shock and injury can occur if eiec-
3. Lift top of panel off supports
tricity remains connected.
4 Replace
with a 40.watt appliance
bulb.
5 Replace
panel in reverse order.
Pull Off the Dial;
Out at the Bottom
Removing the base grille...
rMetal
Clips 7
,
1. Open the doors.
2. Pull grille outwards as shown.
3.
Do not remove Tech sheet
fastened behind grille
2 Push firmly to snap into place.
3 Close the doors.
Ice cube trays.. .
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation.
The longer cubes
are stored, the smaller they get.
l
The ice maker will noi operate
until the freezer is
Optional
automatic
ice maker.. .
If you have the automatic
ice maker accessory
or
plan to add one later [Part No. ECKMF-61). there are a
few things you will want to know:
l
The ON/OFF
lever is a wire signal arm.
Down,, .for making
ice automatically;
Up...toshut
off the ice maker.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain
increased
storage capacity.
l
It is normal for ice crescents to be attached
by a
corner. They will break apart easily.
On
Lower Signal
Arm to Start It.
Signal
Maker.
l
You will hear water
running
when ice maker
is
working.
You'll hear ice fall into the bin. Don't let
these sounds bother you.
To remove ice:
1. Hold tray at both ends.
2. Slightly twist
cold enough to make ice. This can take overnight.
l
Because
of new plumbing
connections,
the first
ice may be discolored
or off-flavored.
Discard the
first few batches
of ice.
l
If ice is not berng made fast enough and more
ice
is needed,
turn the Temperature
control to a higher
number. Wait a day and, if necessary, turn the Air
Control to a higher number.
l
If you remove
the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin.
push it all the way in and lower the arm to the ON
posrtion.
l
If cubes are stored too long, they may develop
an
off-flavor...like
stale water, Throw them away. They
will be replaced.
Cubes
in the Ice bin can also
become
smaller by evaporation.
0 Good water quality is important for good ice quality
It is not recommended
that the ice maker be con-
nected
to a softened
water supply. Water softener
chemicals
such as salt from a malfunctioning
soft-
ener can damage
the ice maker mold and lead to
poor quality ice. If a softened water supply cannot
be avoided,
then it is important
that the water soft-
ener be well maintained
and operating
properly.
7
Advertisement
Table of Contents
