Film Capacitors; Vactrols; Jack Sockets; Leds - JOLIN LAB BATA Build Manual

film capacitors:

Snap them in. Don't mind their polarity.
8 C1, C2, C3, C4, C5, C8, C9, C10
2 C6, C7
1 C12
1 C11

vactrols:

Match the short leg of the vactrol with the squared solder pad on the PCB.
tip: it's easier to bend at 90° degree all the four legs before trying to fit the vactrol in place.
8 U1, U2, U3, U4, U5, U6, U7, U8

jack sockets:

Wait to solder them: just place all of them in the right place and move to the next step.
J1, J2, J3, J4, J5, J6, J7, J8, J9, J10, J11, J12, J13, J14, J15, J16, J17, J18, J19,
24 J20, J21, J22, J23, J24

LEDs:

Short leg goes into the square pin. Don't solder them yet
2 D1, D4
2 D7, D8
2 D3, D5
2 D2, D6
ok, flip the board. we are almost done
Green_3mm
Yellow_3mm
Orange_3mm
Red_3mm
100n
220n
470n
680n
VTL5C1
PJ398SM