Table of Contents
Advertisement
ClearMark Advanced Printer
WARNING:
• The supply voltage must match the voltage given on the printer rating nameplate.
• Only connect the device to a properly grounded and fused socket.
• Do not use a socket that is already being used by devices that are turned on and off at regular intervals, such as photocopiers or
fans.
• Do not connect the printer to either a switch-operated or a timer-controlled power outlet.
• If you connect the ClearMark Advanced printer to the power supply via an extension cable, ensure that the total nominal current
of all of the devices connected to the extension cable does not exceed the ampere rating for that extension cable.
• Verify that the total nominal current of all devices connected to the wall socket does not exceed the ampere rating for that
socket.
• When connecting the printer to the power supply, make sure that the building installation is protected by an appropriate
backup fuse.
SHOCK HAZARD:
• Warning of electrical hazard if the power cable is damaged.
• A damaged power cable can cause a fatal electric shock and lead to a fire.
• Do not place any objects on the power cable.
• Do not pull hard on the power cable and do not bend it any more than necessary.
• Failure to comply with these instructions can cause an electric shock or a fire.
• Insert the plug in a nearby socket and make sure that the socket is readily accessible.
Connect the Power Cable
1. Connect the power cable to the printer (A) and
verify that the plug is inserted firmly.
IMPORTANT • Do not switch off the printer; the printer automatically goes into standby mode.
• The operating parameters are only retained while the printer is turned on. These parameters ensure, for example, that the
printhead is cleaned optimally.
• Turning off the printer or not using it can cause blockage of the ink nozzles after a while.
• Only turn the printer off to replace the service kit.
8
Turn the Printer On/Off
A
Rockwell Automation Publication 1492-QS005D-EN-P - February 2020
1. Turn on the printer by briefly holding down the
on/off switch (A)
Advertisement
Table of Contents
