Download Print this page

Brew Express BE-112 Manual

Valve re-set procedure

Hide thumbs Also See for BE-112:

BE-112

VALVE RE-SET PROCEDURE

Please remove the Brew Express brewer unit from the wall by removing the outside mounting

screws. After removal of outside screws, grab the sides of the brewer and pull away from the wall.

Upon removal, press the grey button on the white colored water line connection to disconnect the

water line.

Table of Contents

Do you have a question about the BE-112 and is the answer not in the manual?

Page 1 VALVE RE-SET PROCEDURE Step #1: Please remove the Brew Express brewer unit from the wall by removing the outside mounting screws. After removal of outside screws, grab the sides of the brewer and pull away from the wall. Upon removal, press the grey button on the white colored water line connection to disconnect the...
Page 2 Step #2: • Place Brew Express upright on a flat surface (as shown in picture below). (You may need to place a book under the brewer to make it level) • Connect an exterior extension cord to the rear of the unit as shown.
Page 3 Step #3 • Locate IRD-Reset label on side of the brewer. • Remove label called “IRD RESET”. Please note: If your unit does not have this label or access hole to re-set your IR, please consider sourcing a repair service or replacement. Step 4 •...
Page 4 Step 5 • After removing the label, use a rigid straw or cu-tip to push the re-set button. • Push in the button and release. After 5-8 seconds, push again to set memory. • Test unit by trying to turn it on. •...
Page 5 Step #7 • Re-install Brew Express into the wall. Be sure to “Snap” water connection together for a firm connection. • Re-install outside mounting screws. • Remove and clean spray-head • Run 2 pots of water without spray-head to purge any debris in the system.