Hitachi D 10VC Manual

1. ASSEMBLY/DISASSEMBLY GUIDE:

The circled numbers in the descriptions below correspond to the
part numbers in the Parts Price List for Type D10VC.

1-1 Disassembly:

A. Disassembly of Parts Within the Handle:

(1) Remove the Handle Cover:

Loosen the M4 x 20 + -Hd. Tapping Screws
the Handle Cover

(2) Remove the Carbon Brush:

With a small minus-head screwdriver, lift up on the Brush
24
Holder , and pull it out slightly. Next, pull out the
terminal portion which connects the Carbon Brush
the lead wire from the Reversing Switch Ass'y
pulling the terminal, it is best to push the Carbon Brush fully
into the Brush Holder (see Fig. 2).
Intermal Wire
Brush Holder

(3) Remove the Cord:

Loosen the M4 x 16 + -Hd. Tapping Screws
the Cord Clip
the Cord Armor
B. Disassembly of the Armature Ass'y and Stator Ass'y:

(1) Loosen the M4 x 50 + -Hd. Tapping Screws

M4 x 35 + -Hd. Tapping Screws
9
Cover , and remove the Gear Cover from the Housing
18
. Then, remove the Inner Cover Ass'y
connected Armature Ass'y
MODEL
22 .
Terminal
Carbon Brush
24
Push
29 , and remove the Cord
31
.
14 from the Housing.
D 10VC
21
, and remove
25 and
27
. When
Carbon Brush
Stop Piece
25
Fig. 2
28
which retain
30 together with
8 and the
7
which retain the Gear
11
and the
−#1 −
Terminal
Convex Portion