Table of Contents
Advertisement
Problems solving
•
If any sensor is faulty, segment in its position is blinking.
Change faulty sensor as soon as possible, system is not fully functional.
•
If irregular false obstacle indication occurs, it can be one of the following problems:
Frost on sensors
Sensors are placed too low
Rear side of some sensor is in contact
with vehicle chassis
• If any protruding part in the rear of the vehicle causes unwanted obstacle indication (e.g. spare wheel, towing hook...),
increase step by step parameter 11 value from 0 (Factory Setting) until problem is solved.
Clean sensors
Use angle brackets (12) or (25) to tilt axe of sensors upwards
Create separation between sensor and vehicle body
Advertisement
Table of Contents
Need help?
Do you have a question about the FBSN-8TRF and is the answer not in the manual?