Installation; Link Led Status - FATEK FBs-W2C User Manual

1.5 Installation

Directly plugged FBs-W2C in port 0 (port 1 for HB1 series). It can automatically
detect the baud rate. After the detection, it will set the port 0 (port 1 for HB1
series) baud rate as 115200 bps.
If using HB1 series PLC, please update the firmware version of W2C to V1.3.1 or
above. The baud rate of the port 1 cannot use 4800 bps. For instructions on
firmware upgrade, please refer to Chapter5 Firmware Upgrade (OTA).

1.6 LINK LED Status

LINK LED is in red, the LED will have different signal status depends on FBs-W2C
currently state. Table 3 shows the various signal status of LED.
Connection Status
Connecting
Disconnected
Execute Smart Config
Execute OTA
Table 3: LINK LED Operation Mode
FBs-W2C User Manual
LINK LED
On and off every 3 secs
Off
Continuous flash
Triple flash
4