Table of Contents
Advertisement
1. Ensure that the unit is powered down.
2. Remove the 10 panel screws and washers.
3. Gently lift the panel away from the case and disconnect the panel from
the battery.
4. Turn the panel over so that you can get easy access to the electronics
side of the panel. Gently rest the panel on your work area, allowing the
weight of the panel to rest on the handles.
5. Gently unplug the Sub-panel from the main PCB. In the event that it
is hard to remove, gently rock the connector back and forth until you
can wiggle the connector free.
6. Lift the panel and place it back into place in the case, then remove the
4 sub-panel mounting screws.
7. Lift the sub-panel free from the panel and place the new sub-panel
into position.
8. Replace the sub-panel mounting screws.
9. Flip the panel over and connect the subpanel to the main PCB.
10. Flip the panel over and reconnect the battery wires to the panel.
11. Position the panel into the case, ensuring that no wires are being crushed.
12. Replace the 10 panel screws and washers, tightening in directly opposite
screw locations first.
13. Ensure that the unit powers back on.
506279-000
Fig. 7
19
Fig. 8
REV. A
Advertisement
Table of Contents
