Table of Contents
Advertisement
Replacing reflector bowls and surface units:
1.
2.
Be s&e the surface unit controls are on "OFF."
Put the reflector bowls back into their places. Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl.
3.
A
Hold the surface unit level with the prongs (terminals) pointing at
the plug-in
With the prongs srarted in the plug-in, start pushing in on the surface
unit. At the same time. lift a little on the side of the surface unit that's
by the plug-in
Make sure the surface-unit prongs are pushed into the plug-in as far
as they WIII go. The surface unit will fit into the reflector bowl and be
level when everything has been done right.
5.
Cleaning under the cooktop:
To clean the area under the cooktop, lift the front of the cooktop at
the center. Raise the swina-un rod to hold it. iBe sure the tie of the rod is
when replacing.
in the notch in the cooktop) Gse warm soapy water and a spbnge or cloth.
Scouring powders or any other abrasive cieaner may harm porcelaln-
enamel finishes and can scratch chrome
Be careful not to raise the cooktop so high that it touches the
control console. And don't drop it Dropping the cooktop can chip or crack
a hard porcelain finish. or damage side panels and surface units.
Prop up the top with
support rod.
Removing the outer oven window:
Oven windows have several panes of glass to help hold the heat in
the oven. The outer glass and frame can be removed if you wish to clean
between the two. It Isheld on by screws at the top, and tabs hidden at the
bottom.
1.
2.
3.
with
1.
With the overt dc!or ciosed remove the screws from the top of the
outer window frame
Tip the frame out about two inches (5 cm) from the door. (The
frame and glass are one piece, so don't worry
about them
coming apart 1
Lift up on both si<fes of the frame to pull the tabs out of the slot at
the bottom of the endow
opening.
To replace the frame and glass. line up the bottom of the frame
the opening in the door.
Tilt the frame so that the tabs fit into the slot at the bottom of the
window opening.
Remove screws; swing
out top. Lift up at
bottom.
'\
'\
t..ii
;'
'Y /
7?
Pull to stop. Lift; pull
again.
2
Tilt the frame as far as you can and push down
3.
Push the frame In the rest of the way and replace the screws.
Removing the storage drawer:
The drawer below your oven is meant to store pots and pans.
Never keep anything in there that will burn or melt.
You may want to remove the drawer for cleaning under the range.
Pull it straight out until it stops Lift the front and pull some more to get it
over the stop. Nou: slide it out until it stops again. Lift the drawer away
from the range until it slips out of the guides.
To put it bat-k. fit the side rails at the back of the drawer into both
guides on the range Push it closed while lifting the front to get past the
stops.
13
Advertisement
Table of Contents
