Table of Contents
Advertisement
1.
Be sure surface
unit controls
are OFF.
Receptacle
\
Opening
I
2.
Line up opening
in the reflector
bowl and
notch
in trim
ring
with
the surface
unit
receptacle.
3.
Hold the surface
unit as level
as possible
with
the
terminal
just started
into
the
receptacle.
4.
While pushing
the surface
unit terminal
into
the receptacle,
lift a little on the edge
of
the unit nearest the receptacle.
5.
When the terminal
is pushed
into the re-
ceptacle
as far as it will go, the surface
unit
will fit into the trim ring.
Reflector
bowls
reflect
heat back
to the
utensils on the surface
units. They also help
catch
spills. When they are kept clean,
they
reflect heat better and look new longer.
If a trim ring gets discolored,
some of the
utensils
used
may
not be flat enough.
Or
some may be too large for the surface
unit.
In either case, some of the heat that is meant
to go into or around
a utensil
goes
down
and heats the trim ring. This extra
heat can
discolor
it.
1.
To remove,
lift
and remove
griddle
cover.
THE GRIDDLE
2.
Lift front slightly
by the handle.
3.
With both
hands, pull
griddle
toward
you to unplug
it.
14
Advertisement
Table of Contents
