Panasonic PAN1780 Integration Manual page 17


PAN1780 Bluetooth Module
Jumper Layout
JP3
JP4
JP8
JP9
JP7, JP10
JP11
JP12
JP13
Module Integration Guide Rev. 1.1
Description
Module reset connected
Module reset disconnected
SWD connected
SWD disconnected
Module UART connected
Module UART disconnected
Module V connected
CC
FTDI connected to module
UART
Breakout pins of JP2
connected to module UART
3.3 V are supplied to the
breakout pin
3.3 V are not supplied to the
breakout pin
Module V connected
CC
Module V not connected
CC
1, 3: GND
2, 4: NFC Antenna
4 Reference Design
Access to module and
programmer SWD.
Access to module UART Rx
and Tx.
Module V connection and
CC
GND pin. The module V
CC
jumper can be removed for
current measurements.
Option for module UART to
breakout pin or FTDI. Place
jumpers either just on JP7 or
JP7 and JP10.
Option to power an external
sensor board with 3.3 V.
Option to break 3.3 V supply
via JP9 and connect 5 V
supply to pin 1 of JP12 to
power the module.
Option to connect NFC
antenna to PAN1780 module.
Page 17 of 44