Lift-Up Cooktop; Using The Self-Cleaning Cycle - Whirlpool RF360BX Use And Care Manual

I
Lift-Up Cooktop
1.
Lift front of cooktop at both front
corners until the support rods lock
into place.
Personal Injury and Product
Damage Hazard
l
Be sure both support rods are
fully extended and in the
locked position. Failure to do
so could result in personal
injury from the cooktop acci-
dentally falling.
l
Do not drop the cooktop.
Damage can result to the por-
celain and the cooktop frame.
2. Wipe with warm soapy water. Use
a soapy steel wool pad on heav-
ily soiled areas.
3.
To lower the cooktop,
lift cooktop
from both sides while pressing the
support rods back to unlock them.
Lower the cooktop into place.
Using the Self-Cleaning Cycle
The Self-Cleaning cycle uses very
high heat
to burn away soil. Before
you start, make sure you understand exactly how to use the Self-Cleaning
cycle safely.
Before You Start
1.
Clean the areas shown by hand.
They do not get hot enough dur-
ing the Self-Cleaning cycle for soil
to burn away. Use hot water and
detergent or a soapy steel wool
pad on...
l
The inside of the door. (The cen-
ter area of the door does not
need to be hand cleaned.)
l
The frame around the oven.
DO NOT clean, move or bend the
fiberglass seal. Poor cleaning and
poor baklng will result.
2. Remove the broiler pan and any
pots and pans you
may have
stored in the oven.
NOTE:
The broiler pan (without
grid] can be cleaned in the oven
only if most of the soil has been
removed by hand-cleaning or a
dishwasher. The chrome broiler
grid will discolor if cleaned in the
Self-Cleaning cycle.
3.
Wlpe out any loose soll or
grease.
This will help reduce
smoke during the Self-Cleaning
cycle.
DOOR AROUND HAND CLEAN