Advertisement
Position either of the side gussets against the inside edge of the previous assembly. Match the letters.
You can hold the small triangle of PCB material while you put a small "tack" on one of the pads. As
before, check for squareness, and a flush joint. See the figure below.
[ ]
"Tack" the other pad on that side.
[ ]
Use the same technique with the other gusset.
[ ]
When you are satisfied with the alignment and squareness of the "tacked" assembly you can go
back and complete the soldering of all the pads. Alternate between different pads and add a
small amount on each pad until the joints are complete.
This completes the chassis.
Now that the chassis is complete. Refer to the graphic below and the PCB silk screening for the
placement of the components.
Do not completely solder the pads.
Page 4 of 10
regen_100418.pdf
Advertisement
