Override Procedures; To Open The Safe With Master Code Using Safe Keypad; To Set A New Master Code (It Must Be 6 Digits) - Minibar Systems SmartBox Operating Manual

3. Override Procedures

For the purpose of security, please change the factory master codes prior
to use. Please keep the emergency key in a safe place.
1)
Note: Do not use Master Code if override procedure is done with Handheld Unit
SMARTBOX OPERATING MANUAL—JUNE 2009

TO OPEN THE SAFE WITH MASTER CODE USING SAFE KEYPAD

a) Enter the master code in use (pre-selected 0-0-0-0-0-0)
b) the door will open automatically, display will show "OPENED"

To Set a New Master Code (it must be 6 digits)

To change the master code, the safe must be opened (i.e. the bolts are retracted).
a) Press key "*" twice, the display shows "PROG"
b) enter old master code (pre-selected 0-0-0-0-0-0).
c) When display shows "NEW", enter a new master code of 6 digits.
d) The display will show "AGAIN". Re-enter the new master code, the display will show
"DONE" to indicate that new master code has been changed successfully.
(see Chapter 3.3 To Open the Safe with Handheld Unit)
5