Table of Contents
Advertisement
Reminder:
Software is installed completed. "Get DataLog's Identifier" shows as below, then press SETTING button to
enter Logger setting from the tool bar.
If logger is not plugged in USB port, the warning message "Reminder: Data Logger is not plugged in USB
port!" shows as below. Replug the USB to PC, and restart the software, if the warning message shows again,
follow NOTE1 below to find the correct COM port.
NOTE 1:
If software message box show as above, follow the steps below:
a) Click "My computer" "Content" in hardware content, click "Device manager" to find the listed (COMx)
under ports (COM % LPT as below. If you may find "Prolific USB- to-Seriral Comm port, it means the
logger is connected to computer properly.
b) Remember the Comm port number and go back to software
c) Click "Setting" "Comm port" select the port number as you see from step1, then press OK button.
Logger Setting:
P
c i
1
P
c i
2
Pic 3
7
Advertisement
Table of Contents
