Table of Contents
Advertisement
!! ATTENTION!!
Do not attempt to open the meter or sensor probe, or the warrant is expired.
In normal measurement mode, turn on the meter, fan activates immediately around every 3 seconds,
for first time use, it takes couple minutes to warm up, display shows 00000 means the meter is under
warming up status, when warm up finished, display will show current O
SUPPLIED:
1. Meter with remote sensor probe and cable
2. Batteries AAA x 6 pcs
3. USB cable (Data transmission)
4. Clear tube 30cm length
5. CD with software
6. Plain box
7. Operation manual
8.
Black shoulder carrying pouch
BUTTON DESCRIPTION
Temp/RH/DP/WB,
O
alarm value setting
2
Fan On/Off
HOLD: Freeze current readings (Hold shows at button of LCD); increase value (Adjust calibration value, O
alarm threshold value).
MODE: Toggle shows DP (Dew point)àWB (Wet Bulb) temperature; move to left digit (O
mode). Long press button for 6 seconds to entering calibration mode.
PWR: Power on (Press in one second) or power off (Press more than 2 seconds). When meter is off, press
HOLD+PWR to disable Auto Power Off function, LCD will show "n" icon.
Short press PWR button to turn on/off alarm with
MAX/MIN: Cycle viewing Maximum .Minimum of O
Long press to clear Max/Min readings from powered on.
SET: Long press button more than 2 seconds to enter O
(SAVE shows button of LCD a few seconds).
Short press button, the display will show "fnOF" to turn off electric fan; Short press again, the display
show "fnOn" to turn on electric fan.
UNIT: Change units °C or °F of temperature, DP and WB.
BKLT: Adjust / decrease alarm setting value of O
+, Hold
, MAX/MIN
Temp/DP/WB °C °F
–
icon.
readings; move to right digit (O
2
alarm threshold setting, long press again to save.
2
threshold under alarm setting.
2
value automatically.
2
Remote sensor probe with cable,
LEDs Built-in O
, Temperature,
2
Humidity, sensors and electric fan.
alarm setting
2
alarm setting mode).
2
2
2
Advertisement
Table of Contents
