Table of Contents
Advertisement
There are up to 32,004 points memory capacity, you may select from 1,000 points up to 32,004 points
ü
from pc software, the total 10 recording status bars are divided by total memory points, you may see the
recording status from bars on LCD.
ü
Great feature: If you select Rollover or Key start mode to record data, you don't have to reset up each
parameter or setting from PC after downloading, i.e. After download stored data to PC, meter may long
press BKLT button to repeat recording immediately.
KEYSTART (Logging purposes):
Long press BKLT button to activate datalogging (Make sure you set KEY START as record mode in
software).
SOFTWARE INTRODUCTION:
INTRODUCTION DATALOGGER SOFTWARE:
USB driver installation
A.
Install logger driver before install software on Window system
The PL2303_Prolific_DriverInstaller_v110.exe driver is for Windows operation system, follow the
installation steps hereunder:
a) Step 1. Put the CD into CD driver, click "PL2303_Prolific_DriverInstaller_v110.exe'' for driver
installation.
b) The set up status.
c) Click "NEXT" to continue.
d) After complete the installation, press "Finished".
B.
Install the logger software for Windows XP or above (For 1
software, please remove the old version first.
Follow below steps to install software:
a) After install USB driver, find "Setup.exe" to start installation.
b) Select the destination folder you want to save by click "Browse" button.
c) Once you finish the selection, press "Next".
d) Select "I accept the License Agreement(s)", press NEXT button.
e) Click "Next" button.
f) Press Finish button to complete the installation.
Restart the Windows XP system.
C.
Run the software from Windows XP or above
a) Plug the USB cable into USB port, since you have already installed the USB driver, computer will
automatically detect logger.
b) Find "Datalogger" in STARTà PROGRAMS
c)
Select logger software folder
st
time installation the software), reinstall the
6
Advertisement
Table of Contents
