Siemens SIMATIC OEM PP32 Equipment Manual page 23

OEM Push Button Panel Equipment Manual
Release 08/98
Refer to the following table for the significance of the various menu items:
Name
DEFAULT Used to select whether all the parameters should be reset
to the predefined system settings values.
CONNECTION Used to select the system connection type. Either MPI or
DP / MPI PROFIBUS-DP.
SLAVE-ADR Defines the slave address of the Push Button Panel in
the PROFIBUS-DP system.
PP-MPI-ADR Defines the MPI address of the Push Button Panel.
BAUDRATE Defines the baud rate for data transmission using con-
nection type MPI or PROFIBUS-DP in KBaud.
DATA MB / DB Used to select whether the data area for the Push Button
Panel is created as a Memory Byte (MB) or Data Block
(DB).
MW Defines the number of the first, reserved memory word
for the Push Button Panel.
DB Defines the number of the data block in which the data
area for the Push Button Panel is reserved.
DW Defines the number of the first, reserved data word for
the Push Button Panel in the data block.
PARAM.-DB Defines the number of the configuring data block.
PLC-ADR Defines the address of the PLC to which the Push
Button Panel is connected.
PLC-TYPE 2 / 3 Used to select the type of PLC to which the Push Button
/ 400 Panel is connected.
RACK-NO Defines the number of the rack in which the PLC is
installed.
SLOT-NO Defines the number of the slot within the rack.
HSA Defines the highest station address within the MPI sys-
tem. The highest station address must correspond to the
setting in the MPI network.
NUMBER OF Defines the number of the MPI master in the system.
MPI-MASTER
Starting Up the Push Button Panel
Explanation
2-5