CPS BLACKMAX BTLDTW Manual

BLACK
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Reverse
KEY FEATURES
• Ensures OEM torque setting
compliance
• Ideal for HVAC mini-split installations
• Jaw opening:
Front (imperial) 3/16" -1-3/8"
Rear (metric) 5 to 35 mm
• Selectable auto-off: Conserves battery
life.
• Display light key
• 4 torque settings: Lbf.ft, Lbf.in, N-m ,
Kgf.m
• Target vs. current torque indicator
• Torque indicator LEDs- Green= within
50-98%, Red= within 2%
• Ten torque standard presets:
5 common, 5 open presets for custom
torque values
• Track mode: View real time torque value
reached during use.
• Peak mode: Maximum torque value
reached is stored temporarily.
S
www.cpsproducts.com
Durable Molded
Handle
Pivot Point
GENERAL SAFETY INSTRUCTIONS
� IMPORTANT:
Please read these instructions thoroughly and carefully before operation. These instructions will provide
you with important information regarding the
&DANGER
Risk of electric shock. Do not use on live electrical circuits. Electrical shock can cause injury.
Plastic
&WARNING
1. For safety,
breakage.
2. Force against flex stops on flex head can cause head breakage. Broken hand tools, sockets or
accessories can cause injury. Excess force can cause crowfoot or flare nut wrench slippage.
3. Wrench user and bystanders should
4. Be sure all components including adaptors, extensions, drivers and sockets are rated to match
or exceed torque being applied.
5.
Observe
when using this wrench.
6. Do not use wrench near center of strong disturbance, strong magnetic field, or
strong corrosive gas or liquid.Do not immerse in water or other liquids.
7. Never remove batteries with wet or bare hands.
�CAUTION
1. If wrench is used without observing information given under this symbol,
or damage to the product may result.
2. For accuracy, periodic recalibration is necessary to maintain accuracy.
3.
4.
5. Ensure wrench capacity matches or exceeds each application before proceeding.
6.
7. Do not press or damage the LCD display.
®
8. To avoid damaging wrench,
9. Do not press power key to turn wrench off while torque is applied.
10.
Always PULL
11.
# BTLDTW
DIGITAL TORQUE WRENCH
TO BE OPERATED BY QUALIFIED PERSONNEL ONLY
Green LED (torque
within 50-98% of
programmed value)
Lighted
Display
flandte is not fully insulated.
do not exceed permitted maximum torque
equipment, system and manufacturer's
if you know or suspect its capacity has been exceeded.
Verify calibration
if wrench has been dropped.
Verify calibration
Avoid excessive bump or shock.
Do not drop or throw wrench.
NEVER apply force when power is off.
ON before using it.
{Do not pushl
on wrench handle.
should something give.
Never hold or operate wrench with wet hands.
operation, warnings, and safety cautions.
Over-torquing can cause
value.
wear safety goggles.
warnings, cautions and procedures
minor personal injury
Always turn torque wrench
Adjust your stance to prevent a
Battery Compartment
Replacement Cap
(BTLDTWCX)
possible fall
1