Download Print this page

Roxtec B frame Installation Instructions

Frame Assembly

Remove the protective foil from the

sealing strip on every short side.

Assemble the frame by inserting the bolts and tighten the nuts. The frame

can easily be assembled around already routed cables or pipes.

For correct casting of frames

into concrete walls, casting

moulds in cellular plastic are

available.

Before concrete is poured,

the frame and casting mould

is ﬁxed in position with the

frame ﬂange inside the wall.

Installation Instructions

Roxtec B frame

To be able to make a correct

installation the size of the

opening in the wall must be 5 mm

(0.197") wider than the inside

dimensions of the frame on all

sides. The reason for this is the

fact that the stayplates need this

space to be able to move inside

the frame during installation and

compression.

The B frame cast and sealed in

concrete wall.

Table of Contents

Do you have a question about the B frame and is the answer not in the manual?

Page 1 Before concrete is poured, The B frame cast and sealed in the frame and casting mould concrete wall. is ﬁxed in position with the frame ﬂange inside the wall.
Page 2 An optional below). Hole in ﬂange Ø = 9 mm (0.354”). rubber gasket can be placed between frame and cabinet/wall. B frame, aperture dimensions for bolted installations Height tolerance Width tolerance ± 5 mm, ±0.197" ± 5 mm, ±0.197"...
Page 3 Remove any dirt inside the frame. Lubricate the inside surfaces of Adapt modules which are to hold Achieve a 0.1-1.0 mm gap between the frame with Roxtec Lubricant, cables or pipes by peeling layers until the two halves when held against especially into the corners.
Page 4 Disassembly Reverse order Packing space Frame sizes 2 , 4, 6 and 8 accommodate the following height of modules: 60 mm, 120 mm, 180 mm and 240 mm. As example shows for frame size 6 the 180 mm can be the result of 4 rows of RM 40 plus one row of RM 20.