Franke AQUATIMER A3000 Installation And Operating Instructions Manual page 8

12.6 Screw on the hook-in strip.
12.7 Hook-in the stainless steel housing.
12.8 Mark the other drill holes.
12.9 Remove the stainless steel housing.
12.10 Drill according to the markings.
Insert the dowels.
12.11 Strip the shielding (a) off from the system lines (approx. 40 mm).
12.12 Place the union nut (c) on the system line (b) up to the stop.
☞
The cable cores are marked with numbers 1 through 4.
A: Union nut
B: FAR Order No. 2000104272
FAR Order No. 2000104274
FAR Order No. 2000100801
FAR Order No. 2000100852
A
1 brown
2 white
3 blue
4 black
12.13 Latch the cable cores (d) into the cable core guides (e) according to their colours.
12.14 Cut off the protruding ends of the cable core so that they are flush, i. e. so that they
do not protrude.
12.15 Install the line connections between the electronic module, the solenoid-valve
cartridges and the Piezo-button.
A: Solenoid valve cartridge mixed water (Actuator 1)
B: Not used
C:Analogue output 0-10 V
D:Not used
E: Temperature sensor mixed water (optional)
F: AQUAPAY coin-operated switch (optional)
G:Piezo-button
H:Electrical T-junction, system lines (Power)
K: Electronic module
12.16 Remove the protective film from the shower panel.
12.17 Seal the shower panel (e.g. with Chromol, not part of the scope of delivery, see
Accessories, Chapter
12.18 Only when the water connection is from the rear: Bring forward work steps 2.13
through 2.15.
B
red
white
blue
black
21).
- 8 -