Electrical Requirements - Whirlpool JMC2127 User Manual

NOTE:
A microwave oven spacer kit is available from your dealer that will
allow the microwave oven to be installed in an 18¼" (46.4 cm) to
19 " (49.4 cm) maximum cutout height. Match the color and
size to the following kits:
Microwave Oven Spacer Kit
27" (68.6 cm) Black - Model JMCSK27WB
27" (68.6 cm) Stainless Steel - Model JMCSK27WS
30" (76.2 cm) Black - Model JMCSK30WB
30" (76.2 cm) Stainless Steel - Model JMCSK30WS
To order, see the "Assistance or Service" section of the Use and
Care Guide.
Minimum Installation Clearances
For proper installation the following minimum clearances must
exist above and below the cabinet opening.
Installation Above Single Built-In Oven
A
B
A. Upper cabinet
B. Lower single oven*
*Approved models: JJW3430, JJW2430, JJW2427, JJW2330,
JJW2327
4
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1"
GROUNDING INSTRUCTIONS
(2.5 cm)
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
1"
and grounded.
(2.5 cm)
WARNING:
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
Electrical Connection
Microwave oven must be connected to the proper electrical
voltage and frequency as specified on the model/serial number
rating plate. The model/serial number rating plate is located on
the left-hand side trim.
Observe all governing codes and ordinances.
Required:
A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a
fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.

Electrical Requirements

WARNING
Electrical Shock Hazard
Improper use of the grounding plug can
A
A. Model/serial number plate