After Unpacking; Transport; Storage; Cleaning - IMC CRONOS-PL Getting Started

1.9 After unpacking...

Check the delivered system immediately upon receiving it for completeness and for possible transport
damage. In case of damage visible from outside, proceed as follows:
·
Do not accept the delivery or only accept it with reservations
·
Note the extent of the damage on the packing documents or on the delivery service's packing list.
·
Begin the claims process.
Please check the device for mechanical damage and/ or loose parts after unpacking it. The supplier must
be notified immediately of any transportation damage! Do not operate a damaged device!
Check that the list of accessories is complete (product package):
·
AC/DC-power adaptor (not for racks) with cable and pre-assembled LEMO connector
·
DC-power LEMO connector
·
Signal connector, included in delivery:
for imc CRONOS-PL and imc CRONOScompact, for CRONOS-SL optional
·
Getting started with your imc measurement device (printed)
File a claim about every fault as soon as it is detected. Claims for damages can only be honored within
the stated claims period.

1.10 Transport

When transporting imc CRONOS-PL/-SL/compact, always use the original
packaging or a appropriate packaging which protects the device against knocks
and impacts. If transport damages occur, please be sure to contact the imc
Customer Support. Damage arising from transporting is not covered in the
manufacturer's guarantee. Possible damage due to condensation can be limited
by wrapping the device in plastic sheeting. The represented handling label for
lithium ion batteries can be attached also independently printed on the package
(e.g. by gluing on the package or in a transparent unlabeled document bag).
Note however that the form and the format are accurately given by IATA and the
expression has to take place in color. Format: 120 x 110 mm.

1.11 Storage

As a rule, the measurement device can be stored at temperatures ranging from -20°C to +85°C
(-40°C to 85°C for CRONOS-SL).

1.12 Cleaning

·
Always unplug the power supply before cleaning the device. Only qualified service technicians are
permitted to clean the housing interior.
·
Do not use abrasive materials or solutions which are harmful to plastics. Use a dry cloth to clean the
housing. If the housing is particularly dirty, use a cloth which has been slightly moistened in a
cleaning solution and then carefully wrung out. To clean the slits use a small soft dry brush.
·
Do not allow liquids to enter the housing interior.
·
Be certain that the ventilation slits remain unobstructed.
© 2018 imc Meßsysteme GmbH
Note
imc CRONOS-PL/-SL/compact - Getting Started, Version 5 R 7 - 2018-06-28
After unpacking... 11