Display Messages - Stoneridge SE5000-8 Workshop Manual

Display Messages

There are four type of messages that can be seen on the display.
Messages - contains information on processes or reminders to the driver. Messages are not stored and can not be
l
printed. Press the Back button to clear the message.
Pre-warnings - appear as early reminders to the warnings. Pre-warnings, except DDS and WTD related, are stored
l
and can be printed. Press the OK button twice to clear the Pre-warning.
Warnings- appear in the event of e.g. overspeeding or violations of the law or if tachograph not can be recording.
l
Warnings are stored and can be printed. Press the OK button twice to clear the Warning.
Faults - are more critical than warnings and are displayed if there is a fault detected in the tachograph, in the sensor
l
or driver card. In addition faults are presented if tampering with the equipment is detected. Faults are stored and can
be printed. Press the OK button to acknowledge the Fault.
Display
Absence of
GNSS pos info
Activation
Activation
complete
Activation
failed
Description
Message
Entry not possible while driving. Related to
the operator.
The VU is unable to detect any valid GNSS
satellite signal for a long time
Message
The tachograph is being activated for use
(Workshop card). Related to the tachograph
Message
The tachograph activation process has been
completed (Workshop card). Related to the
tachograph
Message
The tachograph activation process has
failed (Workshop card). Related to the
tachograph
Display Messages
Action
Stop the vehicle and try the entry again.
If the symbol still is present when vehicle
stopped, disconnect and reconnect the
tachograph and retry.
If the symbol still is present after reconnect,
tachograph must be decommissioned.
Make sure the GNSS antenna is not covered
with or close to large metallic parts
Wait until the automatic activation is
completed.
Eject the workshop card from the
tachograph.
Check system connections.
Re-insert the workshop card to retry the
activation.
Disconnect the tachograph for 30 seconds
and retry.
If the tachograph will not activate it must be
decommissioned and replaced.
- 39 -