Kenmore 417.4194 Series Installation Instructions Manual page 11

Installation Instructions
Connecting drain and electrical
1 Snap one end of the drain hose hanger
(shipped in washer drum) onto the drain
hose. Continue wrapping it around the
hanger and snap it in place.
2 Place the hook end of the drain hose
in the drain opening. Secure the drain
hose with the cable tie (provided in the
enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the
water.
Cable Tie
IMPORTANT
Check to ensure the power is off at the
circuit breaker/fuse box before plugging
the power cord into an outlet.
3 Plug the power cord into a grounded
outlet.
Grounding type wall receptacle
Power cord with
3-prong grounded plug
4 Turn on the power at a circuit breaker/
fuse box.
5 Carefully slide the washer to its final
position. Recheck for level and rock
corners for stability. Remove and discard
door tape.
6 Read the Use & Care Guide provided
with the washer. It contains valuable and
helpful information that will save you
time and money.
7 If you have any questions during initial
operation, please review the "Service
Prevention Checklist" in your Use & Care
Guide before calling for service.
8 Place these instructions in a location near
the washer for future reference.
NOTE
A wiring diagram and technical data sheet
are located under the washer top panel,
on top of the detergent dispenser housing.
11
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.