Setting Up The Microscope; A) Insert Battery; B) Charge Battery - TOOLCRAFT LAB 5.0 Operating Instructions Manual

Digital microscope camera
Table of Contents

Advertisement

Available languages

Available languages

9. Setting Up the Microscope

a) Insert Battery

• Match polarity as shown in the battery compartment (A15).

b) Charge Battery

Do not charge the battery via mains power supply while the microscope is connected to a powered USB
2.0 port. This may cause the battery to overheat.
32
• The battery will charge via USB cable or mains
power supply.
- Connect the supplied charging cable to the
5V/DC charging port (A8) at the back of the
base, and the other end to a power outlet.
- Or connect the supplied USB cable to the
USB port (A10) at the back of the base,
and the other end to the USB port on your
computer.
• The battery indicator LED (A6) will glow red to
indicate that the battery is charging, and turn off
when the battery is fully charged.
• When it is time to recharge the battery, a low
battery icon will show on the bottom right corner
of the LCD display.

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LAB 5.0 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

1713199

Table of Contents