Operation; Maintenance; Environment Protection; Weee Regulations - Sealey MS900PS Instructions

loCKinG
buTTon
Fig.2

6. operaTion

warninG! ensure you read, understand and apply the safety instructions in section 1.
‰
6.1. ensure the power control switch is not locked on before plugging into the mains.
6.2. Hold the polisher firmly with one hand on the handle grip and the other on the side handle. To select the required speed rotate the
speed selector switch (fig.3.2) to the required speed 1 to 6.
speed settings: range from 1000rpm - 3000rpm
6.3. To start the polisher press and hold down the safety lock button (fig.3.1) and squeeze the trigger. When releasing the trigger, the
safety lock button will engage, preventing the polisher from being inadvertently started.
warninG! the high speed settings are intended for sanding. if used for polishing an excessive amount of surface material may
‰
be removed or if polishing at too high a speed the tool will burn through paintwork. for this reason it will not be necessary to use the
tool at a speed setting above 3 (2000rpm no load).
Note: As the rubber support disc is flexible, when sanding it should not be used head on, but at an angle of approximately 10 to 20
degrees.
6.4. contact your sealey stockist for details of compound heads and lambs wool bonnets.

7. mainTenanCe

warninG! Before attempting any maintenance ensure the unit is unplugged from the mains power supply.
‰
7.1. Keep the machine clean and dry. do noT use abrasives to clean the unit. ensure all external head screws are tight.
7.2. Clean regularly by blowing a jet of compressed air through side vents to ensure motor ventilation is kept clear.
warninG! Wear approved safety eye protection and, if necessary, respiratory protection.
‰
Note. The following maintenance must only be carried out by a technically qualified person or an authorised Sealey service agent.
7.3. Check carbon brushes by removing each side screw (fig.4). Check to see if the brushes are worn or cracked. If so, the brushes must
be replaced to avoid sparking and damage to the armature. Always change brushes as a pair. use only genuine spare parts as these
are specifically designed for the machine. Failure to do so may be dangerous and will invalidate your warranty.
7.4. After each 500 hours of use replace the gear head grease to prevent gear wear and possible drive failure.

environmenT proTeCTion

recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.

weee reGulaTions

Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, Kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7ar
01284 757500
© Jack sealey limited
2
1
Fig.3
01284 703534 sales@sealey.co.uk
Original Language Version
Fig.4
www.sealey.co.uk
ms900Ps | issue 4 (sP) 10/10/17