Advertisement
Secure the control horn on the elevator with three
M2.5*16mm screws. Insert the Z-bend wire into the
hole of the servo arm. On the control horn, secure the
ball link with a M2*10 screw and M2 nut.
KIT version only: Locate an E450 size motor. Secure it
into the fuselage with four screws
KIT version only: Connect your motor to your ESC.
Install the prop on the motor.
Use foam safe glue to secure the fuselage wing on the
fuselage.
The CG should be 60mm (2.3-2.4in) from the landing
edge of the wing.
7
Advertisement
