General Information - Westfalia 321 505 300 107 Installation Instructions Manual

GB
Installation Instructions
Electrical System for Towing Hitch
Westfalia Order No.:
Area of Application:

General Information:

Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical set may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer etc.) may be lost.
During trailer towing the rear fog light of the pulling vehicle is switched off by the control unit.
Before operating this electrical equipment on older towed vehicles, install a rear fog lamp if they do
not already have one .
The failure of a turn signal, including on the trailer, is indicated by an increase in the flashing frequency.
As a result, no additional flashing check is required.
An electrical socket adapter may only be used during trailer towing, and must be removed after trailer
towing is completed!
The German version of these installation instructions shall be applicable in event of any legal
questions.
Subject to modification!
20
321 505 300 107 / 113
321 512 300 107 / 113
321 520 300 107 / 113
VW Passat B5 and GP as of 10/96
Saloon and variant
7/13-pin