Changing The Battery - Schaudt CSV 409 Instruction Manual

5.3

Changing the battery

Starting up
the system
8050101 BA / EN
CSV 409 A caravan charging system instruction manual
Changing the battery
ATTENTION!
Y
Wrong battery type or incorrectly connected battery!
Will damage the battery or the devices connected up to the caravan
charging system:
Batteries shall only be changed by qualified personnel.
F
Follow the instructions of the battery manufacturer.
F
The caravan charging system is to be used solely for connecting the
F
12 V power supply to 6-cell lead-gel or lead-acid batteries. Never use
unapproved types of battery (e.g. NiMH batteries).
Only batteries of the same type and capacity should normally be used,
Y
i.e. same as those installed by the manufacturer.
You can change over from lead-acid to lead-gel batteries. You cannot
Y
change over from lead-gel to lead-acid batteries! Your vehicle manufactu-
rer will provide you with information about this.
 Disconnect the battery from the caravan charging system by switching
the 12 V main switch off.
 Unhitch the caravan from the towing vehicle.
 Replace the battery.
 Check once more to ensure that you have fitted the correct type of bat-
tery afterwards.
DANGER!
Y
Battery selector switch set incorrectly!
Danger of explosion caused by the build up of oxyhydrogen gas.
Set the battery selector switch to the correct position.
F
ATTENTION!
Y
Battery selector switch set incorrectly!
The battery will be damaged.
Set the battery selector switch to the correct position.
F
 Disconnect the caravan charging system from the mains before resetting
the battery selector switch.
 Move the battery selector switch (Fig. 2, Pos. 21) into the relevant posi-
tion using a thin object (e. g. ball-point pen):
Lead-gel battery: Set the battery selector switch to "Lead-gel" (Gel).
F
Lead-acid battery: Set the battery selector switch to "Lead-acid"
F
(Säure).
 Start the system as instructed in Chapter 5.2.
Issued: 20.02.2020
9