Option Setting; Setup Com Port - Daikin TYPE4 Checker Instruction Manual

7-3 Option setting

7-3-1 Setup COM port

Selecting communication port which is connected to checker.
On PC side, installed (available) communication ports are managed as COM number. Please use appropriate COM
port number to communicate. Default selection is COM1.
(1) Select COM port to use
Note) In case of no COM port with "Silicon Labs CP210x USB to UART Bridge"
It is necessary to install driver files of USB serial port.
Please obtain appropriate driver installer files from your local Daikin
representative, or could be downloaded from below URL.
https://www.silabs.com/products/development-tools/software/usb-to-
uart-bridge-vcp-drivers
(3) Press [OK] button to save changes
If this setting is not correctly done, communication error
takes place. (see [1-2-3 Required to do before recording] for
more details)
(1) Press [Port(P)] in [Setting(S)] menu
Click the top box (list) and select COM port from listed port
number. From listed COM port numbers, please select COM
port number which comes with "Silicon Labs CP210x USB to
UART Bridge" in the middle box.
AS0112-P-DENV
46