Step 5: Select The Destination Device; Selecting The Destination - HP 300 Series Software Installation Instruction

Step 5: Select the Destination Device
You should see the Destination Menu, below (if you do not see this menu,
something is wrong. Unload the install tape from the tape drive, remove the
tape, turn everything OFF, and start the process again):
HP-UX INSTALLATION UTILITY -- DESTINATION MENU
Select one of the following disks (name and system location) .. ,
Disk
Search Again
Other disk
Select Bus Unit
Code Addr Num
, Select ,
, Item ,
Selecting the Destination
Vol
Num
, Exit
'Install
The Destination Menu lists all connected disks, including the disk's select
code, bus address, unit number, and volume number. From the Destination
Menu, select the destination disk (that is, the disk on which you want to install
HP-UX) as follows:
1. Using the arrow keys, move the highlight bar until you've highlighted the
name of the disk that will be the destination disk.
2. Press either "Select Item"
(®)
or
[Return ).
Installing the HP-UX Operating System 2-7