Table of Contents
Advertisement
For your continued safety and to reduce the risk of injury or electric shock,
please follow all the safety precautions listed below.
WARNING!
• Never stop the appliance before the end of the drying cycle unless all
items are quickly removed and spread out so that the heat is dissipated.
• The appliance must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly switched
on and off by a utility.
• If you will not be using the machine for a while such as when you go
on holiday, disconnect the plug from the mains supply and turn off the
water supply. This is particularly important if there is no drainage around
the machine.
• If the water supply is left on, water pressure may build up and cause a
leak. Turn off water supply after use.
General Use
• Transit bolts are used to transport the machine. You should remove these
using a spanner or similar tool before you install the machine. If you do
not, it will cause strong vibrations when the machine is spinning.
• Do not install your machine anywhere that is damp or exposed to
explosive materials. If you do, it may cause an electric shock, fire, failure
or deterioration.
• Do not pour water directly onto any part of the machine. It may cause a
short circuit or electric shock.
• Items that have been soiled with substances such as cooking oil,
acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and
wax removers should be washed in hot water with an extra amount of
detergent before being dried in the appliance.
• Items such as foam rubber (latex foam), shower caps, water-proof
textiles, rubber-backed articles and clothes or pillows fitted with foam
rubber pads should not be dried in the appliance.
• The machine can be used on textiles suitable for machine washing and
drying.
• CAUTION: Do not connect the machine to hot water. The machine works
with cold water only.
• The appliance is to be connected to the water mains using the new
SAFETY WARNINGS
WASHER DRYER
1
Advertisement
Table of Contents
Related Manuals for Logik L8W5D20
Summary of Contents for Logik L8W5D20
- Page 1 SAFETY WARNINGS WASHER DRYER For your continued safety and to reduce the risk of injury or electric shock, please follow all the safety precautions listed below. WARNING! • Never stop the appliance before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
- Page 2 hose-set supplied. Old hose-sets should not be reused. • Before you start using the machine, turn the tap on to check that the hose is properly connected. If it’s not, there may be a water leak. • Do not put too much laundry or detergent into the machine. It may cause issues with the machine or laundry.
- Page 3 guarantee and could lead to malfunction and cause fire or injury. Power Source and Cable • Use an independent household dedicated mains socket. If the machine is plugged in with other appliances, it may overheat and cause a fire. • Make sure the mains plug is pushed firmly into the socket. A loose connection may overheat and cause electrical shock or a fire.
- Page 4 • Remove all objects from pockets such as lighters and matches. • The door may be very hot during operation. Keep pets and children away. • Be careful when draining hot water or any detergent from the drum. • Do not dismantle, repair or modify the machine. It could malfunction and cause a fire or injury.
- Page 5 WARNING IT IS HAZARDOUS FOR ANYONE OTHER THAN AUTHORISED SERVICE PERSONNEL TO CARRY OUT SERVICING OF REPAIRS WHICH INVOLVE THE REMOVAL OF COVERS. TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT REPAIRS YOURSELF. READ OPERATOR’S MANUAL...
- Page 8 Visit Partmaster.co.uk today for the easiest way to buy electrical spares and accessories. With over 1 million spares and accessories available we can deliver direct to your door the very next day. Visit www.partmaster.co.uk or call 0344 800 3456 (UK customers only) Calls charged at National Rate.
- Page 9 8kg/5kg Washer Dryer Instruction / Installation Manual L8W5D20...
-
Page 11: Table Of Contents
Contents Unpacking ............................4 Installing Your Washer Dryer ......................5 Choosing the Right Location for Your Washer Dryer ...................5 Moving and Installing .........................6 Removing the Transit Bolts ............................6 Removing the Polystyrene Foam ..........................6 Moving the Washer Dryer from One Location to Another ................6 Hose and Cable Lengths ..............................7 Levelling the Washer Dryer ............................7 Water Supply Hose ................................7... -
Page 12: Unpacking
Thank you for purchasing your new product. We recommend that you spend some time reading this instruction manual in order that you fully understand all the operational features it offers. Read all the safety instructions carefully before use and keep this instruction manual for future reference. -
Page 13: Installing Your Washer Dryer
Installation INSTALLATION Installing Your Washer Dryer Please read and follow the instructions carefully. • In addition to the instructions mentioned here, special regulations of the relevant water and power supply companies may apply. If in doubt, have the machine connected by a qualified technician. -
Page 14: Moving And Installing
INSTALLATION Moving and Installing Removing the Transit Bolts Four transit bolts keep the interior of the machine in place while it’s being moved. They need to be removed before installation. Use a spanner (not supplied) and follow the instructions detailed below. Don’t run the machine without removing the transit bolts, as this can cause excessive vibrations and may damage your machine. -
Page 15: Hose And Cable Lengths
INSTALLATION Hose and Cable Lengths How to connect from the left side How to connect from the right side ~80cm ~130cm ~90cm ~40cm 110 -135cm Levelling the Washer Dryer There are levelling feet on the underside. They must be adjusted to make sure the machine is level. -
Page 16: Water Drain Hose
INSTALLATION Connecting the Water Supply Hose 1. To prevent leakage from the connection 3/4” 3/4” joints, ensure the rubber washer seals are fitted to each end of the water supply min. 10 mm min. 10 mm hose. Do not use without the seals in Plastic joint place. -
Page 17: Connecting To The Mains Supply
INSTALLATION Connecting to the Mains Supply For your safety: • Do not use a mains plug adapter or extension cable. • If the mains cable or mains plug are damaged, stop using them and call a qualified technician for assistance. •... -
Page 18: Product Overview
Product Overview The unit Detergent Control Panel Compartment Window Service Panel... -
Page 19: The Control Panel
The Control Panel Door Programme Dial Lock Drum Different wash programmes can icon be selected according to your Clean wash requirements. Button Child Delay If not using the machine or Press to clean after the washing programme, Lock Wash the drum and ensure to turn the dial to OFF icon icon... -
Page 20: Preparation
Preparation Read the following to understand how best to prepare your laundry for washing. Organising Laundry • Read the washing label on each garment to help you sort your washing into different loads. • Sort the laundry by colour, type of fabric and by how soiled it is. This will help you choose the correct programme and temperature for each wash. -
Page 21: Adding Detergent And Softener
Adding Detergent and Softener • Add detergent into the appropriate dispenser. • Apply softener before you start washing. Main Wash Main wash Detergent detergent • Apply detergent and softener according to the washing amount, the soiling level, the water hardness in your area Softener Softener and the manufacturer’s instructions of these products. -
Page 22: Before First Use
Before First Use Before washing your clothes for the first time, run a full wash programme first: 1. Connect the machine to the mains power supply and the water supply. 2. Put a small amount of detergent in the detergent drawer. Close the drawer. 3. -
Page 23: Selecting The Programme
Selecting the Programme Here are the available programmes. Water temperature can be selected separately for certain programmes. Detergent Box Wash/ Default Default Time Default Dry Load Temp. (˚C) (hr) Speed (rpm) Case Case Softener (kg) Programme Case Cotton 3:48 Sports 0:45 Express 15’... -
Page 24: Delay Start The Programme
“1 Hour W/D” programme is suitable for the washing and drying of small and thin synthetic items. For big and thick items (such as big towels and jeans), using this programme may not dry the thick items completely. • Washing times depend on programme and temperature settings selected. •... -
Page 25: Important Information
Important Information Washing Delicates (wool and silk) • Silk laundry loads: 2kg or less • Approximate Weights: - Wool sweater (400g) - Silk blouse / under garment (200g) - Trousers (400g) Adding Delicate Laundry Items to the Drum • Close zips and buttons. •... -
Page 26: Maintenance - Cleaning The Washer Dryer
Maintenance - Cleaning the Washer Dryer Always unplug the machine before cleaning. To prevent build-up of detergent residue, it is recommended to wash the appliance without any load or detergent once a month. Cleaning the Drum Any rust left inside the drum by metal articles must be removed immediately with chlorine-free detergent. -
Page 27: Cleaning The Drain Filter
Cleaning the Drain Filter Be careful not to burn yourself while cleaning the drain filter. Water draining from the filter compartment may be hot after a high temperature wash. Before cleaning the drain filter, switch off and unplug the machine. 1. -
Page 28: Hints And Tips
Hints and Tips Issues Solutions Buttons don’t work. • Child lock is activated. Deactivate the child lock function. • The machine is operating a programme. The Programme Dial was turned to a different programme. • Door doesn’t open. • Door lock may be active. •... - Page 29 There’s not much foam. • This can happen if you’ve put powder detergent directly into the drum – you must put it in the detergent drawer. • The amount of foam can vary, depending on the temperature, level and softness of your water. •...
-
Page 30: Questions And Answers
Questions and Answers Issues Reasons Solutions • Check if the door is closed tightly. • Check if power plug is inserted properly. Machine cannot start up • Check if water supply tap is opened. • Check if Start/Pause button is pressed. •... -
Page 31: Error Codes
Check if the clothes are pinned by the door. Others • Please call the service line if there is any other problem. Specifications Model L8W5D20 Rated voltage 220 - 240 V~ 50 Hz Maximum current 10 A Rated power input... - Page 32 IB-L8W5D20-200723V1...
Need help?
Do you have a question about the L8W5D20 and is the answer not in the manual?
Questions and answers