Table of Contents
Advertisement
General Information
1.3 Installation
1.3
Installation
To install the software, you need a PC with the operating system already installed and running
and the program setup CD. You should also have at least a basic knowledge of the PC and be
familiar with Windows® operating system commands.
1. Close all applications running
2. Insert the CD in the drive.
3. From the CD, start the ATC_Setup.exe program.
4. If a previous installation is already present on the hard drive, then the installation program
will automatically start a procedure to remove the older revision. After this, the installation
process will start.
5. A window is displayed asking you to specify the directory in which you want to install the
program. To change directory, enter the new name in the specific box.
6. Follow the instructions that will be shown until the end of installation.
7. Reboot the PC.
1.4
Technical Support
For further assistance, refer to:
Technical Support on the Internet:
Internet address of Technical Support
http://www.siemens.com/lowvoltage/technical-support
4
Remote Control Software Manual, Edition 03/2011, A5E02469028-02
ATC5300
Advertisement
Table of Contents
