Table of Contents
Advertisement
Available languages
Available languages
CommISSIonInG tHE DEVICE
9. Automatic turn-off
The device turns off automatically at the end of the selected operating period. This saves energy and also
provides additional assurance that the device is not operating without supervision.
10. After use, please disconnect the power plug from the power socket.
troUBLESHootInG
Problem
The device is not connected to
the power supply system
The device does not
The device is not switched on
warm up.
The device is defective
The device and the control are not
On the controller
connected with each other or are not
display screen, the
connected with each other correctly.
letter "E" is shown
The device is defective.
CArE InStrUCtIonS
•
Be sure to unplug the device from the socket before cleaning the device!
•
The device can be washed by hand or in the washing machine at 40° C with mild detergent.
•
Do not iron the device.
•
Do not use a detergent that contains bleach.
•
Do not dry clean the device
•
The device should not be dried in a dryer.
•
Do not use any form of high-pressure cleaner.
•
Be sure to avoid allowing the control to come into contact with liquids as these can result in damage to the
control.
•
Never use the device when it is wet or damp. Do not turn on the device while it is still drying.
•
Allow the device to air dry. Do not use any means to hold the device in place while drying (e.g. clothes
pins) as this could damage the wires and/or cables inside the underblanket.
Storage and regular inspection
•
Do not ball up the device. Carefully fold the product to store it.
•
Store the device in a dry place when it is not in use.
•
Allow the device to cool before you fold or roll it up.
•
Inspect the device and the power cable for possible signs of wear or damage at regular intervals.
•
Please do not use any chemical moth protection.
•
Do not place any heavy objects on the device during storage, as this may damage the electrical wiring.
•
In the event of malfunction or defects, send the device to the manufacturer.
Cause
Insert the power plug into the power
socket and switch on the device
Switch on the device
Send the device to the manufacturer
Connect the control connector
the device connector
Send the device to the manufacturer
troubleshooting
(G)
with
(H)
.
DE
EN
FR
IT
ES
NL
PL
SE
FI
AR
Advertisement
Table of Contents
