Care And Cleaning; What To Do If - AEG HK634150XB User Manual

12

Care and cleaning

CARE AND CLEANING
Clean the appliance after each use.
Always use cookware with clean bottom.
WARNING!
The sharp objects and abrasive cleaning agents can cause damage to the appliance.
For your safety, do not clean the appliance with steam cleaners or high-pressure cleaners.
Scratches or dark stains on the glass-ceramic cause no effect on how the appliance oper-
ates.
To remove the dirt:
1. – Remove immediately:melted plastic, plastic foil, and food with sugar. If not, the dirt
can cause damage to the appliance. Use a special scraper for the glass . Put the scra-
per on the glass surface at an acute angle and move the blade on the surface .
– Remove after the appliance is sufficiently cool:limescale rings , water rings, fat
stains, shiny metallic discolorations. Use a special cleaning agent for glass ceramic or
stainless steel.
2. Clean the appliance with a moist cloth and some detergent.
3. At the end rub the appliance dry with a clean cloth.

WHAT TO DO IF...

Problem
You cannot activate the appli-
ance or operate it.
An acoustic signal sounds
when the appliance is off.
An acoustic signal sounds 6
times and the appliance deacti-
vates.
The residual heat indicator does
not come on.
Possible cause and remedy
• The key lock or child safety device operates
tion. Refer to "Lock" and "The Child safety device".
• STOP+GO operates
"Stop and go".
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the
control panel.
• Start the appliance again and set the heat setting in less than
10 seconds.
You covered one or more sensor fields. Uncover the sensor fields.
You covered one or more sensor fields. Uncover the sensor fields.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone must be hot, speak to the Service Cen-
tre.
. Stop the function. See the section
. Stop the func-