Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Curtec Packo
Summary of Contents for Curtec Packo
- Page 1 Manual Packo January 2018...
- Page 2 Washing The washing instructions below apply to the cleaning of all CurTec packaging products that are made of polyethylene and polypropylene: Best results will be achieved with a washing installation that is equipped with spray nozzles or a so-called Ultra-Sonic installation.
- Page 3 The following instruction applies to both Packo with innerseal and lid and Packo with two-component lid. To close Packo with two-component lid you can start at point 2. 1. Hold the container firmly with one hand. Place the innerseal on the container with the other hand.
- Page 4 Open The following instruction applies to both Packo with innerseal and lid and Packo with two-component lid. For the opening of a Packo with a two-component lid, point 3 does not apply. 1. Hold the container firmly with one hand. Take the lip of the tamper evident strip with your other hand and tear it off counterclockwise.
- Page 5 Since CurTec has no influence on the use of its packaging by end users, they advise to test each transport mode. It remains the responsibility of end users tp verify whether a package and content comply with relevant transport regulations.
- Page 6 Attention! The weights mentioned in the table have been established after simulation and can only serve as indications. CurTec recommends users to perform tests at all times. Attention! This data is only relevant if Packos are placed in non- supporting cardboard boxes. The total weight of Packos placed on a pallet may never exceed the carrying capacity of that pallet.
- Page 7 Example Packo 4305, 2 months, 25° C. The bottom Packo can carry 15 kg according to the table. At a total weight of 0.75 kg (content + packaging) 20 Packo’s (15 kg/ 0.75) can be stacked on top of the bottom container.
- Page 8 30° C 40° C Attention! The loads mentioned in the table can only serve as indications. CurTec always advises its customers to perform additional testing. Attention! This data is only relevant if Packos are placed in non- supporting cardboard boxes. The total weight of Packos placed on a pallet may never exceed the carrying capacity of that pallet.
- Page 9 8, rounded off + 1 = total number of containers. Example Packo 4306, 1 week, 30° C, air transport: 14/3= 4 kg. This is the total load that may be put on the bottom container in the stack. At a weight of 0.7 kg per container it means that 6 containers in total can be stacked (4 kg / 0,7 kg + 1).
- Page 10 0.02 mm. We advise you not to stack any higher than 2 metres. In case a pallet is placed on top of a Packo pallet, the surface needs to be flat and solid to avoid pressure points on the top layer.
- Page 11 (105) 1200 x 1000 mm 48 x 40 inch Art. no’s 4315 ▪ 4320 ▪ 4325 (66) 1200 x 800 mm (88) 1200 x 1000 mm 48 x 40 inch Packo manual 1801...
- Page 12 CurTec International Spoorlaan Noord 92 5121 WX Rijen The Netherlands UK & Ireland: +44 20 3514 4624 North America: +1 908 450 98 16 All other countries: +31 88 808 2000 curtec.en@curtec.com curtec.com...
Need help?
Do you have a question about the Packo and is the answer not in the manual?
Questions and answers