4
Assembling the spare pressure transducer kit
1.
Pull the brazed set with the pressure transducer (A) through the hole in the partition wall into the compressor
compartment area - see result in compressor compartment area in Figure 4.
2.
Pull the cable of the old pressure transducer through the hole in the partition wall into the compressor
compartment area. - see result in compressor compartment area in Figure 4.
3.
Blind the partition wall with the rubber stepper plug on the brazed set.
Install the assembly bracket for the brazed set [Key 13 mm] – see Figure 4.
4.
Figure 3
Figure 4: Compressor compartment area and assembly bracket
RGL_Unit_CO2_PT5/E/Rev00
1
Assembly bracket
3/5