Selecting A Wash Cycle - Bosch SHI 4300 Use And Care Manual

Selecting a Wash Cycle

The dishwasher will wash and dry the contents based
on cycle selection made. Refer to Tables 3, 4 and 5:
Wash Cycle Selection Chart to select the most ap-
propriate cycle for the wash load.
Follow these steps to select a cycle and start the
dishwasher:
SHU/SHI Models:
1. Close the dishwasher door, making sure
that door latches are closed.
2. Press the on/off switch.
3. Select the button for the program
desired.*
4. The dishwasher will start automatically
and continue to the end of the selected
cycle.
5. At the end of the cycle the dishwasher
will stop and either the "Clean" light will
become illuminated, the LED display will
show"CL" or "0", or the dishwasher will
beep.
SHU 9910/9920/9950/ 8800 & 8810
Models & SHV Models:
1. Open dishwasher door.
2. Press the on/off switch.
3. Push the button once for the program
desired.
4. Close door until it latches and the pro-
gram will begin.
5. Same as #5 above.
Push the desired button TWO TIMES
if another program button is lit up.
SELECTING A WASH CYCLE
Figure 24
Figure 25
Figure 26
*
*
*
www.boschappliances.com
Note: All indicator lights will
remain illuminated until the on/
off switch is pressed or the door
is opened.
Various Model Types
SHU/SHI
SHU 9950
SHU 9910/9920 & SHV Models
VARIOUS END OF
CYCLE INDICATORS
Clean light illuminates
CL or 0 is displayed on the LED.
Cycle Completion Beeper sounds off
ENGLISH - 19