Advertisement
Removing the DC Power Connections from the Cisco cBR Chassis
• #2 Phillips screwdriver
Step 1
Power down the AC FPEM using the power switch.
Step 2
Power down the AC circuit or power source to which the AC power cord is connected.
Step 3
Loosen the Phillips-head screw on the cable retaining bracket using a #2 Phillips screwdriver.
Step 4
Unplug the AC power cord from the receptacle on the AC FPEM.
Figure 1: Removing AC Power Cord from the AC FPEM
1
Screw on the cable retaining bracket
Step 5
Repeat
Step 2, on page 2
Removing the DC Power Connections from the Cisco cBR
Chassis
The terminal block covers are an integral part of the safety design of the product. Do not operate the unit
Warning
without the covers installed. Statement 1077
When you install the unit, the ground connection must always be made first and disconnected last.
Warning
Statement 1046
Cisco Converged Broadband Routers Hardware Installation Guide
2
to
Step 4, on page 2
for each AC power connection.
Maintaining the Power System in the Cisco cBR Chassis
2
AC power cord
Advertisement
