Driver Software The Rane Seventy does not require manufacturer specific drivers on Mac operating systems, and is plug & play with Serato DJ Pro. You may be asked to install the Rane Control Panel, which allows you to adjust mixer settings.
Page 3
Turn on Seventy USB PORT A / B Connect USB cable from PC DECK 2 USB ACCESSORY PORT Connect Rane Twelve or other USB accessory DECK 1 USB ACCESSORY PORT Connect Rane Twelve or other USB accessory PHONO GROUNDING POST...
Page 5
Overview RANE SEVENTY FUNCTION SHIFT FUNCTION CONTROL CHANNEL STRIP Source Select, Channel Gain, EQ, Filter (per channel) MASTER SECTION Adjust Master volume, Booth volume BACK Cycle between Library & Waveform view Cycle fowards between respective panels SCROLL / LOAD Turn to scroll library, press in to load track to...
Performance Pads The Rane Seventy comes with 8 RGB Performance Pads per deck (for a total of 16 pads), which can be used in 7 different pad modes, and 2 further user-mappable pad modes. The first 5 modes can be accessed by pressing the respective pad mode buttons once, and are as follows: •...
Page 7
Performance Pads The next 4 modes can be accessed by pressing the respective pad mode button twice, and are as follows: • PITCH PLAY mode: Press the ‘CUE’ mode button twice to enter PITCH PLAY mode. In this mode, pads 1-8 play Cue points over variable pitch ranges.
Page 8
The Rane Seventy allows for a myriad of FX, via both built-in hardware FX, and control of Serato DJ Pro’s iZotope TM DJ-FX. The large display built into the mixer, allows you to see FX information at a glance. For the purpose of this guide, control of the software DJ-FX will be focused on. Please refer to the Rane Seventy user guide for detailed information on using the hardware FX.
Pitch Play Holding SHIFT and pressing the CUE performance pad mode button on the Rane Seventy will enable Pitch Play mode. In this mode you an play Cue Points over variable pitch ranges. There are 3 key ranges to choose from. The following tables show pitched key ranges (in Semitones) while using the 8 performance pads in Pitch Play mode.
Page 10
Serato DJ Pro or online at https://serato.com/dj/pro/expansions/flip In Cue mode, the Rane Seventy’s Parameter Left button arms & enables Flip for recording, and the Parameter Right button triggers a saved Flip. Holding SHIFT while pressing each button toggles Flip Loop and Flip On/Off respectively.
MIDI The MIDI feature in Serato DJ Pro provides the ability to remap Serato DJ Pro software functions to your primary Serato controller, interface or mixer. You can also assign controls to a secondary MIDI controller to further enhance your performance. For more information on MIDI mapping with Serato DJ Pro click here To remap your supported Serato device, open the SETUP screen and click the MIDI tab.