Table of Contents
Advertisement
Changing the input signal
The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote
Control or TV/VIDEO on the unit.
Remote Control
Device display Unit
Video 1
Signal of source connected to INPUT 1 is displayed.
Video 2
Signal of source connected to INPUT 2 is displayed.
Video 3
Signal of source connected to INPUT 3 is displayed.
Comp 1
Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.
Comp 2
Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.
Comp 3
Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.
RGB 1
Signal of source connected to RGB IN 1 is displayed.
RGB 2
Signal of source connected to RGB IN 2 is displayed.
HDMI
Signal of source connected to HDMI IN is displayed.
Photo (Photo Viewer)
Signal of source connected to CARD SLOT is displayed.
The input mode changes each time this
button is pressed.
1
*
If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 71.)
Card input mode (Photo Viewer) is
selected.
1
*
Changing input is only possible if Cable/
Antenna is set as the Input Set setting.
2
*
If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 71.)
Device display operation
TV
Video 1*
Video 2*
Video 3*
Or
TV (Antenna A)
TV (Antenna B*
Video 1*
Video 2*
Video 3*
1
HDMI*
1
RGB 2*
1
RGB 1*
1
1
Comp 3*
1
1
Comp 2*
1
1
Comp 1*
2
HDMI*
2
1
RGB 2*
)
2
RGB 1*
2
2
Comp 3*
2
2
Comp 2*
2
2
Comp 1*
37
Hide quick links:
Advertisement
Table of Contents
