First Time Setup - Panasonic PT-60LCX64B Operating Instructions Manual

First Time Setup

For your convenience, First Time Set up menu will be displayed on screen when the set is turned on for the
fi rst time. If needed, follow the menus and procedures displayed on-screen for setting up the features.
POWER
SAP
LIGHT
TV VCR DVD
DBS RCVR CBL AUX
TV/VIDEO A - ANTENNA - B
CH
VOL VOL
OK
MENU CH EXIT
1 2 3
4 5 6
7 8 9
R-TUNE PROG
0
PIP MIN PIP MAX
REW PLAY FF
PAUSE STOP REC
PIP CH
FREEZE SEARCH
DVD/VCR CH
TV/VCR OPEN/CLOSE
PIP SPLIT MOVE SWAP
Notes:
• Auto scan must be done when you select the input signal for the fi rst time or whenever you change the antenna confi guration.
• Depending on conditions, Auto scan may take a while.
Input Setup
To select the confi guration of RF input depending on the signal source.
Note:
No video will be displayed in this setup mode.
F i r s t T i m e S e t u p
I n p u t S e t u p S e t t i n g
A u t o S c a n
L a n g u a g e
Procedure
Press VOL ► to select Cable only, Cable/Antenna, or Antenna only.
Press OK to underline your selection.
When the next screen is displayed, press OK to start the Auto Scan. All
available channels with a signal will be programmed into memory.
Auto Scan
This feature allows you to selectively auto scan channels. You can Scan
All, Analog only channels, or Analog & Digital channels.
F i r s t T i m e S e t u p
I n p u t S e t u p
Scan All
Antenna (A) Analog
A u t o S c a n
Antenna (A) Analog & Digital
L a n g u a g e
Antenna (B) Analog
Antenna (B) Analog & Digital
Procedure
Press OK to start Auto Scan.
After Auto Scan is completed the unit tunes to the fi rst channel found
during auto scan.
Notes:
• If DCM (Digital Cable Module) is present during the First Time Setup and Antenna (A)
is set to cable, Antenna (A) will not be scanned due to the DCM providing the channel
map.
• If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then
try Auto Scan again. (PP. 30-31)
Language
The language of the on-screen display is set to English as the factory setting.
You can select English, Spanish or French as the on-screen displays language.
F i r s t T i m e S e t u p
I n p u t S e t u p S e t t i n g
A u t o S c a n
L a n g u a g e
Procedure
Press ◄ VOL or VOL ► to select desired language, then press OK to set.
Power ON / OFF
C H A N G E
C a b l e O n l y
M E N U
t o r e t u r n
S E L E C T
M E N U
t o r e t u r n
C H A N G E
E n g l i s h
M E N U
t o r e t u r n
O K
E X I T
O K
E X I T
O K
E X I T
27