Packaging For Shipment - Tektronix 7D01 Instruction Manual

General Information--7D01 (SN 8020000 & up)
To install the 7D01 in the mainframe, align the 7D01 tracks
with the rails of a vertical and horizontal plug-in compart-
ment. Gently slide the 7D01 into the mainframe and push
firmly to lock the 7D01 front panel flush with the
mainframe.
To remove the 7DO1, grasp the release latch in the lower
left corner and pull the 7D01 out of the mainframe.
PACKAGING FOR SHIPMENT
I f this instrument is t o be shipped for long distances by
commercial transportation, i t is recommended that the
instrument be packaged in the original manner for maxi-
mum protection. 'The carton and packing material in which
your inslrument was shipped should be saved and used for
this purpose.
I f the original packaging is unfit for use or not available,
package the instrument a s follows:
1. Obtain a carton of corrugated cardboard with at least a
200 pound test strength and inside dimensions of no less
than six inches more than the instrument dimensions; this
will allow for cushioning.
2. Surround the instrument with polyethylene sheeting t o
protect the finish of the instrument.
3.
Cushion the instrument on all sides by tightly packing
dunnage or urethane foam between the carton and the
instrument, allowing three inches on all sides.
4. Seal the carton with shipping tape or an industrial
stapler.
Also, if this instrument is t o be shipped t o a rektronix
-
Service Center for service or repair, attach a tag t o the
instrument showing the following: Owner of the instru-
ment (with address), the name of an individual at your firm
-
that can be contacted, complete instrument type and serial
number, and a description of the service required. Mark the
address of the
1
ektronix Service Center, and your return
address, on the carton in one or more prominent locations.
-
REV.
A, M A R 1977
-