Features - Radial Engineering STAGEDIRECT User Manual

®
FEATurE SET
1
13
12
1. PoWEr SuPPLY: Use to connect the included power adapter
(15VDC-400mA). StageDirect may also be powered by 48V phantom.
2. LIFT: Disconnects pin-1 on the XLR output to help eliminate hum and
buzz caused by ground loops.
3. BAL ouT: Lo-Z balanced output used to feed the PA system. Follows
standard AES format with pin-1 ground, pin-2 hot (+) and pin-3 cold (-).
4. 180°: Reverses the polarity at the XLR output to help eliminate acoustic
hot-spots on stage that can cause feedback.
5. rEMoTE: Connection for a momentary (non-latching) footswitch that
enables remote control of the mute function.
6. PHASE: Reverses the polarity at the ¼" AMP output to help eliminate
acoustic hot-spots on stage that can cause feedback.
7. PAd: Reduces the input sensitivity by -10dB to prevent overload from
high output devices like keyboards and active pickups.
8. TunEr: Hi-Z ¼" output allows you to connect an electronic tuner. It is
always active and can be used for silent tuning with the mute footswitch.
9. FILTEr: 3 position high-pass filter used to eliminate excessive bass to
help reduce feedback and low frequency resonance.
10. InPuTS: Two hi-Z ¼" inputs used to connect your instruments.
11. SELECT: Channel select switch with LED's indicating active channel.
12. MuTE: Mutes the stage amp and balanced XLR outputs, leaving the
tuner output active for silent tuning.
13. AMP: Hi-Z ¼" output is used to feed the on-stage guitar or bass amplifier.
Transformer isolated to eliminate noise caused by ground loops.
Radial Engineering Ltd.
2 3 4 6 8
5 7
2
StageDirect™ Active Direct Box
True to the Music
9
11
10