Installing The Grass Box; Initial Operation; Operation; Mounting/Removing The Grass Box - Grizzly ARM 4051 A Lion-Set Translation Of The Original Instructions For Use

GB

Installing the grass box

The collection box is already completely
preassembled.
Now just stretch the rubber lips
of the collection net over the
bars of the grass collection bas-
ket (15).
Attention: Do not operate the ap-
pliance until the collision guard
and grass box are fully installed.
Risk of injury!

Initial Operation

Before operating the machine,
you must
- install the upper and lower upper handles:
- install the collection bag
- If necessary, install the lateral ejection
chute.
Caution! Risk of injury! During
the assembly or disassembly of
the collection bag, the engine
must be turned off and all mo-
ving parts must have come to a
standstill. Remove the battery
from the device before carrying
out any work.

Operation

Caution! Risk of injury! Always
wear appropriate protective
equipment and work gloves
while working with the appli-
ance. Prior to each use, ensure
that the appliance is working
correctly. Ensure that the coll-
ection bag is installed correctly
34
and the device has been moun-
ted properly. Do not use the
device if a switch is damaged.
Personal protective equipment
and a fully functional appliance
reduce the risk of injuries and
accidents.
Adjustments on the mower, as
well as assembly and disas-
sembly of the collection basket,
mulch kit and lateral ejection
chute, etc. may only be made
while the motor is switched off
and the blades are at a standstill.
Switch of the device, pull the igni-
tion key (
blades to come to a stop. There is
a risk of personal injury.
Observe noise control and local
regulations.
Mounting/removing the grass
box
Prior to using the collection box,
the mulch kit (
ejection chute must be removed
(see ).
1. To mount the grass catch box
(15) lift the impact protection (14)
and mount the grass catcher box
(15).
2. Lower the collision guard (14)
onto the grass box (15) - it will
keep it in place.
3. To remove the grass box (15),
lift the collision guard (14) and
unhook the grass box from
the mounting bracket. Flap
down the collision guard to the
housing.
23) and wait for the
22) and lateral